Instruction manual

FS 240, FS 240 R
English
23
Preparations
N Lay your brushcutter on its back so
that the cutting attachment
mounting face is facing up.
Fitting the thrust plate
The machine comes standard with the
thrust plate.
N Slip the thrust plate (1) over the
shaft (2).
NOTICE
The thrust plate (1) on the gearbox is
necessary for mounting cutting
attachments.
Mounting hardware for cutting
attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
Mounting hardware is not packed with
machine
Only mowing heads may be used which
mount directly to the shaft (2).
Mounting hardware is packed with
machine
Mowing heads and metal cutting
attachments may be mounted.
Depending on the cutting attachment, it
may be necessary to use the nut (3),
rider plate (4) and thrust washer (5).
These parts are included in a kit
supplied with the machine and are also
available as special accessories.
Blocking the drive shaft
The output shaft (2) must be blocked
with the stop pin (7) to mount or remove
cutting attachments. The stop pin is
included with the machine and is
available as a special accessory.
Mounting the Cutting
Attachment
002BA104 KN
1
002BA383 KN
2
002BA266 KN
002BA267 KN
3
4
5
7
8
2
002BA384 KN
7