Instruction manual

FS 240, FS 240 R
English
20
N Press throttle cable (14) – if
necessary – into the throttle cable
support (15)
Swiveling the handlebar
Into the transport position
N Loosen the tommy screw (3) and
unscrew it until it is possible to
swivel the handlebar (7) clockwise
N Turn the handle bar 90° and then
swivel it downward
N Tighten tommy screw (3)
Into the working position
N Swivel and turn the handlebar
counterclockwise in the opposite of
the order described above
A factory-new machine comes with the
loop handle already mounted.
Using the Barrier Bar
A barrier bar may have to be mounted to
the loop handle to suit the market and
the cutting attachment you intend to use
– see "Approved Combinations of
Cutting Attachment, Deflector, Handle
and Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
14
15
002BA378 KN
15
14
7
002BA379 KN
3
Mounting the Loop Handle
9926BA001 KN
9926BA002 KN