Instruction manual

FS 240, FS 240 R
English
19
Fastening the handlebar
N Position the handlebar (7) in the
lower clamp (1) so that distance (A)
is not more than 15 cm (6 in.)
N Place the upper clamp on top and
hold both clamps together
N Insert the tommy screw (3) through
both clamps as far as it will go – hold
all parts together and secure them
N Position the entire secured
assembly on the handlebar
support (8) with the tommy screw
facing the engine
N Press the tommy screw (3) into the
handlebar support as far as it will go
and then screw it in – do not tighten
it down yet
N Align the handlebar so that it is
perpendicular to the shaft – check
distance (A)
N Tighten tommy screw
Attaching the control handle
N Unscrew the bolt (9) – remove the
nut (10) from the control handle (11)
N Push the control handle with the
throttle trigger (12) facing toward
the gearbox onto the end of the
handlebar (7) until the holes (13)
align
N Insert nut (10) in the control
handle (11), insert the bolt (9) in the
control handle and turn and tighten
the bolt
Fastening the throttle cable
NOTICE
Do not kink the throttle cable or run it in
tight radiuses – the throttle trigger must
move freely!
A
3
7
002BA381 KN
1
2
3
002BA351 KN
8
13
9
11
12
7
13
002BA438 BL
10