Instruction manual

FS 240, FS 240 R
English
18
Attaching the bicycle handle with
rotating handlebar support
The machine is delivered with the
rotating handlebar support already
attached to the shaft. The clamps must
be removed in order to attach the
handlebar.
Removing the clamps
N hold onto the lower (1) and upper
clamps (2)
N Unscrew the tommy screw (3) –
after the tommy screw has been
unscrewed, the parts are loose and
are pressed apart by the two
springs (4, 5)!
N Remove the tommy screw – the
washer (6) remains on the tommy
screw
N Hold onto the lower clamp (1) and
remove the upper clamp (2) – in
doing so, separate the parts so that
the springs (4, 5) retain their
position in lower clamp
If the spring (5) has slipped out of the
lower clamp (1):
N Replace and/or press the spring into
the groove of the clamp as shown
Mounting the Bike Handle
2
1
4
5
002BA415 KN
1
5
002BA416 KN