Technical data

13773-001
76-10
Page 8 31 July 2001
(i) At governor, secure rod-end bearing to governor control arm with bolt, washers, nut, and
cotter pin
(j) Wrap fiber paper around portion of control cable which will pass through firewall fitting so a
tight fit is achieved at the cable/firewall interface.
(k) Install clamps or ties securing control cable to engine mount.
(l) Perform Governor Rigging and Maximum RPM Adjustment (Refer to 61-20)
(m) Solvent clean firewall fitting and fitting/cable interface. (Refer to 20-30)
(n) Fillet seal firewall fitting and fitting/cable interface with silicone sealant. (Refer to 20-10)
(o) Install RH and LH aft console trim panel. (Refer to 25-10)
(p) Install washer and control-quadrant friction control knob.
(q) Install RH cockpit seat. (Refer to 25-10)
(r) Install engine cowling. (Refer to 71-10)