Technical data

13773-001
76-10
Page 731 July 2001
D. Governor Control Cable (See Figure 76-102)
(1) Removal - Governor Control Cable
(a) Remove engine cowling. (Refer to 71-10)
(b) Remove cotter pin, nut, washers, and bolt securing governor control cable rod-end bear-
ing to governor control arm.
(c) Remove rod-end bearing.
(d) At forward cable support bracket mounted to engine, remove retaining plate nut, washers,
and bolt and remove control cable from support bracket.
(e) At aft cable support bracket mounted to engine, remove adel clamp securing control cable
to support bracket.
(f) Remove any additional clamps or ties securing control cable to engine mount.
(g) Remove control-quadrant friction knob and washer.
(h) Remove RH cockpit seat. (Refer to 25-10)
(i) Remove RH and LH aft console trim panel. (Refer to 25-10)
(j) Remove cotter pin, castellated nut, and bolt securing governor control rod to throttle cam
follower.
(k) Remove rubber sleeve, nut, and washer securing control cable to console bracket.
Note: Prior to removal, note routing of cable and location of anti-chafing spiral
wrap to facilitate installation. Remove as much sealant as possible from
cable and cable fitting on firewall.
(l) Gently pull governor control cable aft, through firewall, ensuring that the control cable
does not inadvertently pull other components loose, and remove from airplane.
(2) Installation - Governor Control Cable
(a) Acquire necessary tools, equipment, and supplies.
(b) Ensure cable fitting on firewall is clear and free of old sealant.
CAUTION: When routing the control cable, ensure the cable does not interfere with air-
plane control rigging, wires, or hoses.
(c) Route governor control cable from the cabin, through firewall, to engine compartment.
(d) Install rod-end bearings to both ends of control cable.
(e) At console, install washers, nuts, and rubber sleeves securing control cable to support
bracket.
(f) Position rod-end bearing in throttle cam follower and install bolt, washers, nut, and cotter
pin.
(g) Attach adel clamp to control cable and install aft support bracket.
(h) Insert control cable into forward support bracket, align retaining plate over bracket, and
install bolt, washers, and nut.
Description P/N or Spec. Supplier Purpose
High Temperature Silicone
Sealant
RTV 736 Dow Corning Sealant
Fiber Frax Paper 970J,TON-
0146
UniFrax Firewall Insulation