Technical data

13773-001
71-40
Page 2 30 Nov 2000
(d) Remove nuts and washers, and spacers securing cable bracket to engine mounting pad
and remove bracket from airplane.
(2) Installation - Mixture Control Cable Bracket
(a) Align control cable bracket with mounting pad studs and install spacers, washers, and
nuts.
(b) Insert control cable into bracket, align retaining plate over cable bracket, and install bolt,
washers, and nut.
(c) Connect control cable to mixture control arm and install bolt, washers, nut, and cotter pin.
(d) Perform Mixture Control Adjustment/Test. (Refer to 76-10)
(e) Install Engine Cowling. (Refer to 71-10)
D. Fuel and Hose Line Stand-Off Clamps (See Figure 71-401)
(1) Removal - Fuel and Hose Line Stand-Off Clamps
(a) Remove nut, washer, and bolt securing component clamp to stand-off clamp.
(b) Pry stand-off clamp open and remove from airplane.
(2) Installation - Fuel Line and Hose Stand-offs
(a) Position stand-off clamp around induction pipe.
(b) Align component clamp with stand-off clamp and install washer, bolt, and nut.