Technical data

13773-001
71-20
Page 2 30 Nov 2000
(e) Raise or lower hoist just enough to force separation between engine mounting point and
engine mount isolators. Remove isolators from airplane.
(2) Installation - Engine Mount Isolators
Note: If isolator is being reused, ensure isolators are reinstalled in same location as
originally installed.
(a) Raise or lower hoist just enough to insert stepped isolator into engine side of mounting
point.
(b) Install bushing, lower isolator, washers, heat shield, grounding strap (if applicable), and
bolt. Torque to 450 to 500 inch-pounds (49.5 to 55 Nm). (Refer to 20-60)
(c) Install exhaust system. (Refer to 78-20)
(d) Install cowling. (Refer to 71-10)