Technical data

13773-001
57-20
Page 1
AUXILIARY STRUCTURE
1. DESCRIPTION
The leading edge of the wing is manufactured from composite materials. This airplane has a one-piece
wing with individual wing tips. The wing tips are manufactured from composite materials. Each strobe light
module is secured inside the corresponding wing tip.
2. MAINTENANCE PRACTICES
A. Wing Tip
(1) Removal - Wing Tip
(a) Ensure BAT 1, BAT 2, and AVIONICS master switches are in the “OFF” position.
(b) Pull NAV LIGHTS and STROBE LIGHTS circuit breakers.
(c) Remove the screws securing the wing tip to the wing and slide the wing tip outboard just
enough to gain access to the anti-collision/strobe light wires.
(d) Identify and disconnect the anti-collision light assembly wires. Remove wing tip.
(2) Installation - Wing Tip
(a) Place the wing tip into position and connect the anti-collision light assembly wires.
CAUTION: The wires for the anti-collision light must be positioned away from all mov-
ing parts.
(b) Position wires from the anti-collision light away from all moving parts.
(c) Secure the wing tip to the wing with screws.
(d) Reset NAV LIGHTS and STROBE LIGHTS circuit breakers.
30 Nov 2000