Technical data

13773-001
52-10
Page 730 Nov 2000
(5) Adjustment - Cabin Door Latching Mechanism
(a) Open the cabin door and hold the cabin door handle in the full open position (keeping
pressure on the compression springs).
(b) Inspect and measure the clearance between both door pins and receivers using a feeler
gage.
Note: The door pin and receiver clearance should be between 0.0 to 0.05-inch. If
the pins need adjusting, proceed with the following steps.
(c) Remove door trim panel. (Refer to 25-10)
(d) Remove the appropriate rod end and turn the rod end in the corresponding direction.
(e) Repeat the above procedures as required until the specified clearance is obtained.
(f) Secure door trim. (Refer to 25-10)