Technical data

13773-001
33-40
Page 4 30 Nov 2000
B. Anti-collision Strobe Light Assembly
(1) Removal - Anti-collision Strobe Light assembly
(a) Place the Strobe light and NAV light switches in the “off” position.
(b) Pull the Strobe Lights and NAV Lights circuit breaker to open the circuit.
(c) Remove the screws securing the lens retainer to the base plate.
(d) Disconnect the Anti-collision Strobe Light assembly wire harnesses.
(e) Remove the Anti-collision Strobe Light assembly.
(2) Installation - Anti-collision Strobe Light assembly
WARNING:
The anti-collision strobe light assembly with the green lens is for the
right wing tip.
(a) Connect the corresponding Anti-collision Strobe Light wiring harnesses.
(b) Place the corresponding Anti-collision Strobe Light assembly against the wing tip.
(c) Secure the lens retainer to the base plate with screws.
(d) Reset the Strobe Lights and NAV Lights circuit breakers.
(e) Ensure proper Anti-collision Strobe Light operation.
CAUTION: Always wear clean cotton gloves when working with light bulbs. Never allow
the glass portion of the light bulb to come into contact with exposed skin.
Oils from the exposed skin will cause premature bulb failure.