Technical data

13773-001
33-10
Page 6 30 Nov 2000
(13) Removal - Dimmer Switch
(a) Remove the pilot’s kick panel. (Refer to 25-10)
(b) Remove left bolster panel to gain access to dimmer switch. (Refer to 25-10)
(c) Identify each wire to the switch and desolder wires.
(d) Remove nut and star washer securing switch to bolster panel.
(e) Remove switch from bolster panel.
(14) Installation - Dimmer Switch
(a) Place switch into bolster panel and secure with a star washer and nut.
(b) Connect and solder each wire to the corresponding terminal of the switch.
(c) Install left bolster panel. (Refer to 25-10)
(d) Install kick panel. (Refer to 25-10)
(e) Verify proper operation of switch.
B. Lamp Replacement
(1) Removal - Cabin Eyeball Light
(a) Pull CABIN LIGHTS circuit breaker.
(b) Remove cabin headliner.(Refer to 25-10))
(c) To remove the eyeball light bulb, rotate the socket and pull the bulb out.
(2) Installation - Cabin Eyeball Light
(a) Push and rotate eyeball lightbulb assembly into position.
(b) Install cabin headliner. (Refer to 33-10)
(c) Reset the CABIN LIGHTS circuit breaker.
(d) Verify proper operation of light.
(3) Removal - Cabin Dome Light
(a) Pull CABIN LIGHTS circuit breaker.
(b) Gently pry the lens off of the light base.
(c) Remove light bulb.
(4) Installation - Cabin Dome Light
(a) Push eyeball lightbulb into position.
(b) Secure lens to dome light.
(c) Reset the CABIN LIGHTS circuit breaker.
(d) Verify proper operation of light.