Technical data

13773-001
33-10
Page 530 Nov 2000
(7) Removal - CAPS Handle Lighting
WARNING:
CAPS must be serviced and maintained by Cirrus Design trained and autho-
rized parachute system technicians only. Airframe and powerplant license
is not sufficient credentials for performing maintenance on CAPS. Ground
activation of the CAPS will render the system and the airplane unusable
until the CAPS and fuselage have been rebuilt by a certified technician.
(a) Open (pull) the CABIN LIGHTS circuit breaker.
(b) Remove CAPS Activation T-Handle Cover.
(c) Secure CAPS handle with safety pin to prevent accidental discharge of the CAPS rocket.
(d) Remove cabin headliner. (Refer to 25-10)
(e) Disconnect wire harness.
(f) Peel the epoxy away from the CAPS handle lights.
(g) Push the lights inward and disconnect the wire harness. Remove the lights.
(8) Installation - CAPS Handle Lighting
(a) Install and secure LEDs to headliner using 5 minute epoxy.
(b) Connect wire harness.
(c) Install cabin headliner. (Refer to 33-10)
(d) Remove lock from CAPS handle and secure cover.
(e) Reset cabin light circuit breaker.
(f) Verify proper operation of lights.
(9) Removal - Circuit Breaker Panel Lighting
(a) Remove left mid-console circuit breaker trim. (Refer to 25-10))
(b) Push each of the six LEDs out of the circuit breaker panel lighting brackets.
(c) Disconnect the circuit breaker panel lighting wire harness.
(d) Remove the lights and harness.
(10) Installation - Circuit Breaker Panel Lighting
(a) Push each of the six LEDs into the circuit breaker panel lighting brackets.
(b) Secure the lights to the bracket by lightly crimping the edge of the bracket.
(c) Route and connect circuit breaker panel lighting wire harness.
(d) Install left mid-console circuit breaker trim. (Refer to 25-10)
(e) Reset the CABIN LIGHTS circuit breaker.
(f) Verify proper operation of lights.
(11) Removal - Alternate Induction Air and Parking Brake Handle Light
(a) Remove left bolster panel to gain access to the LED. (Refer to 25-10)
(b) Disconnect the LED wire harness.
(c) Push LED out of the panel and remove the LED.
(12) Installation - Alternate Induction Air and Parking Brake Handle Light
(a) Connect wire harness.
(b) Push the LED into position and secure with 5 minute epoxy.
(c) Install left bolster panel. (Refer to 25-10)
(d) Verify proper operation of light.