Technical data

13773-001
33-00
Page 1
33-00LIGHTS
LIGHTS
1. GENERAL
This chapter contains information for troubleshooting, removal, installation and adjustments of the interior
and exterior lighting systems used on the airplane.
Exterior lighting consists of standard wing tip navigation lights with integral anti-collision strobe lights and
position lights. A single landing light is mounted in the lower engine cowling.
Interior lighting consists of separately controlled incandescent overhead lights for general cabin lighting,
individual map lights for the pilots, and dimmable panel flood lights. The flight instruments and avionics
equipment are integrally lighted and are controlled by a single dimming circuit.
WARNING:
Always disconnect the power supply prior to servicing any portion of the electrical
system. Ensure the main power switch is in the off position; then remove the negative
battery cable followed by the positive battery cable.
CAUTION: Always wear clean cotton gloves when working with light bulbs. Never allow the glass por-
tion of the light bulb to come into contact with exposed skin. Oils from the exposed skin will
cause premature bulb failure.
30 Nov 2000