Technical data

13773-001
27-50
Page 330 Nov 2000
D. Flap Circuit Card Assembly (CCA) (See Figure 27-501)
(1) Removal - Flap Circuit Card Assembly
(a) Pull FLAPS circuit breaker.
(b) Remove passenger compartment seats. (Refer to 25-10)
(c) Remove carpet and access panels CF4C. (Refer to 6-00)
(d) Disconnect flap CCA connector.
(e) Remove nuts, washers, spacers, and screws securing flap CCA to longeron.
(2) Installation - Flap Circuit Card Assembly
(a) Position flap CCA to longeron and install screws, washers, spacers, and nuts.
(b) Connect flap CCA connector.
(c) Install access panels and carpet. (Refer to 6-00)
(d) Install passenger compartment seats. (Refer to 25-10)
(e) Reset FLAPS circuit breaker.
E. Flap Relays (See Figure 27-501)
CAUTION: Failure of either flap relay is cause for replacement of both relays. Replace both relays
upon failure of one.
(1) Removal - Flap Relay
(a) Pull FLAPS circuit breaker.
(b) Remove passenger compartment seats. (Refer to 25-10)
(c) Remove carpet and access panels CF4C. (Refer to 6-00)
(d) Firmly pull relay out of socket.
(2) Install - Flap Relay
(a) Position relay on socket and firmly push relay into place.
(b) Install access panels and carpet. (Refer to 6-00)
(c) Install passenger compartment seats. (Refer to 25-10)
(d) Reset FLAPS circuit breaker.