Technical data

13773-001
25-10
Page 6 31 Jul 2001
(8) Installation - Lower Windshield Trim
(a) Install glareshield. (Refer to 34-20)
(b) Secure the upper and lower A-pillar trim on both sides. (Refer to 25-10)
(c) Install both forward door-seals. (Refer to 52-10)
(d) Remove the protective cover from the windshield.
(9) Removal - Center Bolster Trim
(a) Loosen the four screws on the bolster switch panel.
(b) Lift edge of bolster trim and slowly remove the panel.
(10) Installation - Center Bolster Trim
(a) Place trim into position
(b) Using four screws, secure center bolster trim.
(11) Removal - Right Bolster Trim
(a) Remove door-seal. (Refer to 52-10)
(b) Remove right A-pillar trim (lower).
(c) Loosen lower right-side instrument panel screws.
(d) Lift edge of lower windshield trim to slowly release the hook and loop fasteners.
(e) Remove right-hand bolster by cutting the cable tie on the vent tubing and by separating
the RTV seal.
(12) Installation - Right Bolster Trim
(a) Place trim into position and seal vent tubing with RTV and a cable tie. Secure trim.
(b) Secure lower windshield trim. Firmly push on trim in areas of hook and loop fasteners.
(c) Secure lower right-side instrument panel screws.
(d) Secure right A-pillar trim.
(e) Install door seal. (Refer to 52-10)
(13) Removal - Left Bolster Trim
(a) Disconnect battery.
(b) Verify the Start/Ignition Key Switch is in the “OFF” position and remove the key. (Refer to
POH)
(c) Remove door-seal. (Refer to 52-10)
(d) Remove left A-pillar trim (lower). (Refer to 25-10)
(e) Loosen lower-left instrument panel screws.
(f) Remove center bolster trim. (Refer to 25-10)
(g) Remove nut securing the Start/Ignition Key Switch.
(h) Remove allen head screws securing the three interior light knobs.
(i) Remove the four screws securing the bolster switch panel. Remove panel.
(14) Installation - Left Bolster Trim
(a) Secure bolster switch panel with screws.
(b) Secure the three interior light knobs with allen head screws.
(c) Tighten the Start/Ignition Key Switch nut finger tight (snug).
(d) Secure center bolster trim. (Refer to 25-10)
(e) Secure lower-left instrument panel screws.
(f) Secure left A-pillar trim (lower). (Refer to 25-10)
(g) Install door seal. (Refer to 52-10)
(h) Connect battery.