Technical data

13773-001
5-20
Page 5
13. Spark Plugs
Inspect, clean, re-gap and rotate in accordance with Teledyne Conti-
nentals Motors Maintenance Manual, Section 12.
Manual No.
X30634A
❍
14. Spark Plug Cable Leads
Visual Inspection for corrosion and deposits.
5-20 ❍ 50 Hrs
15. Cylinder Cooling Fins
Visual Inspection for cracking, bending, and general condition.
5-20 ❍
16. Engine Baffling and Seals
Visual Inspection for cracks, tears, and rips.
5-20 ❍
17. Ignition Harness
Inspect for high tension leaks and continuity in accordance with
Teledyne Continentals Motors Master Service Manual, Accessories,
Section 3.
Manual No.
X40000
❍
18. Magneto
Functional Inspect magneto to engine timing in accordance with
Teledyne Continentals Motors Maintenance Manual, Section 12.
Internal Inspection every 500 Hrs.
Manual No.
X30634A
❍ Internal
Inspect.
500 Hrs
19. Induction System Filter
Replace at Annual Inspection, at 200 hours, or when filter is more
than 50% covered by foreign material.
5-10 ❍ Annual,
200 Hrs,
or 50%
used
20. Air Intake Ducts
Visual Inspection for general condition.
5-20 ❍ 50 Hrs
21. Alternate Air Door
Check operation of alternate air door.
71-60 ❍ 50 Hrs
22. Fuel Pump
Visual Inspection for leaks, security, and condition.
5-20 ❍
23. Fuel Injection Nozzles
Visual Inspect nozzles and manifold valve for fuel stains, security,
and proper venting every 100 hours.
Every 300 hours and at first 100-Hour Inspection on new, rebuilt, or
overhauled engine, remove and clean fuel injection nozzles per
Teledyne Continentals Motors Maintenance Manual, Section 5.
5-20
Manual No.
X30634A
❍
1st 25
Hrs
300 Hrs
24. Gascolator Fuel Filter and Bowl
Drain and clean.
28-20 ❍ 50 Hrs
25. Flexible Fuel Lines
Visual Inspection for leaks, security, and condition.
5-20 ❍
26. Throttle, Propeller, and Mixture Control Cable
Visual Inspection for security and condition of cotter pins, castel-
lated nuts, and oversized washers.
5-20 ❍
Engine Group (Continued)
Chap-Sect
Reference
Interval
100 Special
Initials
31 July 2001