Technical data

13773-001
11-30
Page 2 30 Nov 2000
(e) Align overlay half with protective backing still in place on panel and press exposed overlay
half onto panel.
(f) Bend overlay back and peel remaining protective backing from overlay.
(g) Carefully work overlay toward opposite panel edge, pressing bubbles and wrinkles out
with rubber roller. Ensure all edges are firmly adhered.
(h) Install panel and surrounding trim (if applicable). (Refer to 25-10)
B. Cast Vinyl Interior Placard
(1) Removal - Cast Vinyl Interior Placard
(a) Acquire necessary tools, equipment, and supplies.
(b) Peel decal away from surface.
(c) Solvent clean surface to remove residual adhesive. (Refer to 20-30)
(2) Installation - Cast Vinyl Interior Placard
(a) Acquire necessary tools, equipment, and supplies.
(b) Water wash surface where decal is to be installed.
(c) Solvent clean surface where decal is to be installed. (Refer to 20-30)
(d) Remove protective backing from decal using care not to contaminate adhesive surface.
(e) Place one edge of decal on surface and work downward to eliminate wrinkles and air
pockets. Avoid stretching decal as poor adhesion will result.
(f) Press decal firmly to surface with fingers or rubber roller. Ensure all edges are firmly
adhered.
Description P/N or Spec. Supplier Purpose
Denatured Alcohol - Any Source Solvent
Clean, white, lint free cloth - Any Source Solvent Wipe
Description P/N or Spec. Supplier Purpose
Denatured Alcohol - Any Source Solvent
Clean, white, lint free cloth - Any Source Solvent Wipe
Rubber Roller - Any Source Application of sur-
face pressure.