Service manual

ELI 250/210__________________________________________________________________________
A-6
workstation. Also, it is required that your IT Manager set the ELI 250 WLAN configuration values. Refer to
section 3 for more information on WLAN configuration setup. The ELI 250 can be configured for DHCP (Dynamic
Host Communication Protocol) and for WEP (Wired Equivalent Privacy) security.
NOTE: environmental conditions may affect the reliability of WLAN transmissions.
If DHCP is set to NO, your wireless access point will have a static network setting and the following parameters
must be configured in the ELI 250:
IP Address
Def Gateway
Sub Net Mask
If DHCP is set to YES, your wireless access point will have an automatic network setting and IP Address, Def
Gateway and Sub Net Mask do not need to be configured.
In either DHCP setting, the following wireless network parameters must be configured in the ELI 250 by your IT
Manager:
Host IP
Port Number
SSID
Channel Number
Note: addresses are always entered as 4 sets of 3 digits; therefore, an address of 192.168.0.7 must
be entered on the ELI 250 as 192.168.000.007.
If WEP Security is disabled on your access point then set Security (WEP) to NO. If WEP Security is enabled on
your access point then the following wireless network parameters must be configured in the ELI 250 by the IT
Manager:
Security (WEP): YES
WEP Key
WEP Key ID
Note: the range for the WEP Key on the ELI 250 is 0-3. If the range on your access point is 1-4,
then 0 at the ELI 250 maps to 1 on the access point; 1 at the ELI 250 maps to 2 on the access
point, etc.
LAN Transmission
For a LAN transmission, set the Default XMT media to LAN from Configuration page 6 (see section 3 of this
manual). It is necessary that the IT Manager of your facility set the ELI 250 LAN configuration values. Refer to
section 3 for more information on LAN configuration setup.
Note: addresses are always entered as 4 sets of 3 digits; therefore, an address of 192.168.0.7 must
be entered on the ELI 250 as 192.168.000.007.
Connect the Ethernet cable to the LAN connection at the rear of the ELI 250, as pictured below.