Service manual

____________________________________________________________________________Section 3
3-15
Configuration Page 6 (optional LAN connectivity)
The ELI 250 connectivity options are RS232 (or direct), modem, LAN or WLAN. Configuration parameters
associated with each type of transmission media will be presented in configuration pages six and seven only if those
media are installed in the cardiograph.
Default XMT Media
Configuration page 6 identifies the default transmission media. Those connectivity options which have been
optionally purchased and installed (RS232, modem, LAN or WLAN) in your ELI 250 will be available for default
selection.
DHCP
This setting defines whether the Dynamic Host Communication Protocol (DHCP) will be used to obtain an IP
address. If DHCP is Yes, the network will automatically and dynamically assign an IP address therefore, there is no
need to manually enter an IP address. If DHCP is No, you must enter the IP address, Def Gateway and Sub Net
Mask.
NOTE: all parameters related to network connection must be entered under the direction of the IT
Manager of the facility where the unit is installed.
IP Address
Define the fixed IP address used by the ELI 250 for network transmission (if DHCP is not selected).
Def Gateway
Enter the address of the default gateway (if DHCP is not selected).
Sub Net Mask
Enter the Sub Net address (if DHCP is not selected).
Host IP
Enter the IP address of the host server.