Instruction manual

MS 201 T
English
27
Removing the starter
N Remove screws (1)
N Lift the fan housing off of the
crankcase and pull it away to the
side
Removing the rope rotor
N Remove the spring clip (1)
N Carefully remove the rope rotor with
washer (2) and pawl (3)
The rewind spring can jump out – risk of
injury!
Replacing a torn starter rope
N Pry the cap out of the starter grip
N Remove remaining rope from the
rotor and starter grip
N Thread the new starter rope through
the starter handle and secure it by
making a simple overhand knot
N Pull the knot into the starter grip
N Refit the cap in the grip
Installing the rope rotor
N Thread the rope from above through
the rope guide bush (1) and rope
rotor (2) and secure with a simple
overhand knot
N Coat the bearing bore in the rope
rotor with non-resinous oil
N Slip the rope rotor onto the starter
post (3) – turn it back and forth a
little until the anchor loop of the
rewind spring engages
Replacing the Starter Rope
and Rewind Spring
1
1
1
1
0012BA016 KN
2
3
1
0011BA022 KN
5902BA019 KN
146BA018 KN
1
0011BA025 KN
2