Instruction manual

MS 201 T
English
20
N Hold and start the chain saw
When the engine has turned over for the
first time
N Move the Master Control lever (1) to
the position warm start n
N Hold and start the chain saw
Once the engine is running
N Press the throttle trigger lockout and
blip the throttle trigger (2); the
master control lever (1) jumps to
run F and the engine begins to idle
N Pull the hand guard toward the
handlebar
The chain brake is released – the chain
saw is ready for use.
Open the throttle only when the chain
brake is off. Increased engine speeds
with the chain brake on (saw chain is
stationary) will quickly damage the
clutch and chain brake.
At very low temperatures
N Let the engine warm up briefly with
the throttle slightly open
N If necessary, configure for winter
operation – see "Winter Operation"
Switching off the engine
N Move the master control lever to the
stop position 0
If the Master Control lever was moved
from the position warm start n to stop 0
– afterwards simultaneously press the
throttle trigger lockout and the throttle
trigger.
If the engine does not start
The master control lever was not
returned from the position cold start l
to warm start n in time, the engine may
be flooded.
N Move the master control lever to the
stop position 0
N Remove the spark plug – see
"Spark plug"
N Dry spark plug
N Crank the engine several times with
the starter – to clear the combustion
chamber
0012BA010 KN
1
H
L
STOP
0012BA011 KN
2
1
H
L
STOP
0012BA002 KN
H
L