Instruction manual

MS 201 T
English
48
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Engine
Single cylinder two-stroke engine
Ignition system
Electronic magneto ignition
Fuel system
All position diaphragm carburetor with
integral fuel pump
Chain lubrication
Fully automatic, speed-controlled oil
pump, additional manual oil flow control
Weight
Cutting attachment
Recommended cutting attachments in
compliance with Sec. 5.11 of ANSI
standard B 175.1-2000
Observe the information about ANSI
standard B 175.1-2000 as well as the
definition "low-kickback saw chain" in
the section "Safety Precautions and
Working Techniques".
Rollomatic E guide bars
Saw chains 3/8" P
Chain sprocket
Specifications
A = 300 hours
B = 125 hours
C = 50 hours
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Displacement: 2.15 cu. in.
(35.2 cm
3
)
Bore: 1.60 in (40 mm)
Stroke: 1.10 in (28 mm)
Engine power to
ISO 7293:
2.4 hp (1.8 kW)
at 9,500 rpm
Idle speed: 3,000 rpm
Maximum permissi-
ble speed with bar
and chain: 14,000 rpm
Spark plug
(suppressed): NGK CMR 6 H
Electrode gap: 0.02 in (0.5 mm)
Fuel tank capacity: 10.5 fl.oz (0.31 l)
Oil tank capacity: 7.4 fl.oz (0.22 l)
dry, without bar and
chain: 8.2 lbs. (3.7 kg)
STIHL reduced kickback guide bars
(with green label)
Bar lengths: 12, 14, 16 in.
(30, 35, 40 cm)
Pitch: 3/8" P (9.32 mm)
Groove width: 0.50 in. (1.3 mm)
Sprocket nose: 9-tooth
STIHL reduced kickback saw chain
(with green label)
Picco Micro Comfort 3 (63 PMC3)
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.050 in. (1.3 mm)
Picco Super 3 (63 PS3)
Pitch: 3/8"P (9.32 mm)
Drive link gauge: 0.050 in. (1.3 mm)
Picco Duro 3 (63 PD3)
Pitch: 3/8"P (9.32 mm)
Drive link gauge: 0.050 in. (1.3 mm)
6-tooth for 3/8"P (spur chain sprocket)