Instruction manual

MS 201 T
English
24
N While pushing down on the cap, turn
it clockwise about 1/4 turn until it
comes to a stop.
The marks on the tank cap and fuel tank
must line up.
N Fold the grip down so that it is flush
with the top of the cap.
Tank cap should be properly tightened.
If the tank cap cannot be locked in the
fuel tank opening
Check cap for tightness. If it can be
moved, the bottom of cap may be
twisted out of the correct position for
installation in relation to top.
N Remove the cap from the fuel tank
and check it from above.
N Place the cap in the fuel tank
opening and rotate it
counterclockwise until it drops fully
into the opening.
N Continue rotating the cap
counterclockwise (about 1/4 turn
until it stops) – this causes the
bottom of the cap to be turned to the
correct position for installation.
N Turn the cap clockwise for closing –
see section on "Closing."
001BA233 KN
001BA231 KN
001BA235 KN
Left: Bottom of cap is twisted out
of the correct position for
installation – inner mark (1)
in line with outer mark.
Right: Bottom of cap in correct posi-
tion for installation – inner
mark is under the grip. It is
not in line with the outer mark
on the cap.
001BA241 KN
1
001BA238 KN
001BA239 KN