User manual

◆ maximum ambient temperature

This device uses a maximum ambient temperature does not exceed 40 ℃

(104 ℉ ).

◆ Protection class IP20

This equipment can prevent the infiltration of a diameter of more than

12mm of solid , but not water proof , water droplets splashing into

◆ anti-lightning

The level of protection for this equipment for Class I , so please connect

the yellow / green wire grounded .

Other lighting wires and the power cord of the device Do not mix then !

Special attention to the marked voltage of the power supply voltage and

host !

Ensure the effective voltage does not exceed the voltage range indicated

on the rear window. You need to refer to the assessment (rear window

label also provides

The maximum number of input power, in order to avoid overload)

◆ ensure that the power plug into the power seat . Make sure that

connecting the device to the main power before the power switch is set

to OFF / OFF state.

◆ Make sure the power cord is not to be broken or sharp objects cut or

damaged, the timing inspection equipment and power lines .

◆ When the device is not in use or disconnect the main power before

cleaning . Disconnect the power cord , pull by the plug , not directly drag

Pull the power cord .

◆ the surface temperature

In the steady state , the equipment surface temperature of up to 100 °

(212 ° F ) .

◆ maintenance

Prior to the start of any repair work or cleaning it , be sure to cut off the

main power supply .

Shutdown , please lamps stand for at least 35 minutes, do not move any

part of the lighting accessories , in order to avoid high temperature

damage . This

The possibility of an explosion after a period of bulb is almost zero.

◆ Lamp

Factory bulb equipped with special lighting . - Please read the bulb

manufacturers to provide the "operating instructions " (with YODN

200W R5 bulb lighting installation instructions ) .

◆ for any damage or thermal deformation , replace the lamp