User manual

To drag the power cord to pull the plug .

◆ This level of protection of the equipment for Class I , so please connect

the yellow / green wire grounded .

◆ line connection , maintenance and service must be carried out by

specialized technical staff .

◆ Do not connect the device in the dimming device .

◆ Do not use in very short time intervals to continuously turn the device

on or off, otherwise it will shorten the bulb

Life.

◆ the first use of the equipment, there may be some smoke or smell . It is

normal to imagine not generation

Table equipment .

◆ Do not directly touch the surface of the device ( the use of process

equipment because the surface of the chassis has been very hot ) !

◆ replacement bulb , make sure that the same power with the original

bulb .

◆ Note ! Watch out for the eyes! Avoid looking directly into the light

source ( especially in patients with epilepsy ) !

Catalogue

Safety

Safety Information

Information

◆ Installation:

Make sure that all parts of the lamps in good condition .

Make sure that before the installation of the fasteners securely .

Safety rope must be properly bound to the device or a fixed frame , in

order to prepare for the lamp hook off the possibility of the whereabouts

of the equipment .

◆ Minimum illumination distance :

Beam need to locate the the lens projected light projection object to

maintain at least a distance of 12 m ( 39'4 ) .

◆ minimum distance with flammable material

Lamps must be fixed installation , and to ensure that at any point of any

flammable materials and lighting the surface for at least 20cm ( 8 ' ) of

Distance

◆ mounting surface

This equipment allows installation in general combustible surface