Specifications

Ver SG 9/200 61 Sharp Electronics Corporation
MOUNTING OVEN TO THE WALL
Two people are recommended to attach the
Microwave Oven/Hood to the Mounting Plate.
1. Thread the Power Supply Cord through the hole
made in the bottom of the top cabinet.
2. Install the oven by sliding it onto the arms of the
Mounting Plate. Push it all the way to the wall. Figure
18.
3. Tighten two Mounting Screws (D) located in the
oven faceplate. See Figure 18.
4. Insert the three lower tabs of the Louver (E) into
the slits of the oven face plate. Then insert three upper
tabs of the Louver (F) into the slits of the oven face
plate. See Figure 19.
NOTE The upper middle tab should be inserted
between the oven faceplate and the outercase cabinet.
5. Replace and tighten one screw (A) (removed in
Section 7 on page 4) to the outercase cabinet. See
Figure 20.
6. Use the two Top Cabinet Screws 3 and two Flat
Washers 4, supplied in the INSTALLATION
HARDWARE, to attach the unit to the top cabinet.
See Figure 21.
7. (For Vertical Exhaust Only).
Attach the Exhaust Damper Assembly 8 to the fan cover on the top of the outercase
cabinet by sliding it into the slits in the same direction as the arrow. Using Tapping
Screw 4 X 12 mm 7 from the INSTALLATION HARDWARE, tighten into place. See
Figure 21.
8. Make a bundle of the Power Supply Cord and attach it to the inside of the cabinet
using the Power Cord Hanger 5. See Figure 21.
Figure 18
Figure 19