Specifications

Ver SG 9/200 60 Sharp Electronics Corporation
9. OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO
THE MOUNTING INSTRUCTIONS FOUND ON BOTH TEMPLATES.
THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON
BOTH TOP CABINET AND WALL TEMPLATES.
NOTE: THIS OVEN SHOULD BE ATTACHED TO AT LEAST ONE WALL STUD.
See WALL CONSTRUCTION step 2.
MOUNTING PLATE
1. Separate 4 Toggle Bolts, 2, packed in the INSTALLATION HARDWARE, from the
Toggle Nuts.
2. Use Wood Screws, 1 to attach Mounting Plate to the stud or studs. Use Toggle Bolts to
attach Mounting Plate through the holes at A, B, C and D; UNLESS THOSE HOLES
ARE LOCATED ON THE STUD. Insert one Toggle Bolt into A, B. C and D where
appropriate (these correspond to the holes of the Wall Template) and put the Toggle Nuts
onto the Toggle Bolts. Figure 15.
Refer to instructions in Wall Template.
3. Position the Mounting Plate with the Toggle Bolts attached at the wall location and
insert Toggle Nuts and Bolts through the holes in the wall with the Toggle Nuts closed.
Figure 16. Use Wood Screws 3 to attach the Mounting Plate to studs.
NOTE: Before insertion, be sure you leave a space more than the thickness of the wall
between the Mounting Plate and the end of each of the Toggle Nuts (in the closed
position). If you do not leave enough space, the Toggle Nut will not be able to open on
the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from
the hole; therefore make sure all of the Toggles are in the correct position before
insertion.
4. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts.
Pull Toggle Bolt toward you and turn clockwise to tighten. Figure 17.