Specifications

Ver SG 9/200 59 Sharp Electronics Corporation

1.Remove and save 2 screws from back edge and 1 screw from the top center of the Fan

Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the

arrow on the Fan Cover Bracket as shown in Figure 9.

2. Withdraw Hood Fan Unit carefully and slip wires out of Wire Box. CAUTION: Do not

pull or stretch hood fan wiring. See Figure 10.

3. Turn the Hood Fan Unit

end-over-end. Rotate the Hood Fan

Unit 90 degrees so that the fan blade

openings are facing upward.

Replace Hood Fan Unit into the

oven. Be

careful not to pinch the lead wire

between the inner bracket and the

Hood Fan Unit. See Figure 14.

4. Put the lead wire into Wire Box.

See Figure 14.

5. Replace the Fan Cover Bracket

by sliding it into the slits in the same

direction as the arrow on the Fan Cover Bracket. Make sure the fan blades are visible

through the top openings in the oven before proceeding. Attach the Fan Cover Bracket to

unit with 3 screws, which were removed in Step 1 above. See Figure 12. The Hood Fan

Unit is now rotated for vertical exhaust operation.

6. Attach the Exhaust Damper Assembly to the fan cover on the top of the outercase

cabinet after mounting the oven. To attach the Exhaust Damper Assembly, refer to

MOUNTING OVEN TO THE WALL, Step 7.

Figure 14