Specifications

Ver SG 9/200 56 Sharp Electronics Corporation
TIP
The dotted cutting line on the packing carton can be cut in order to assist positioning the
oven before placing oven on the Mounting Plate See Figure below right
7. PREPARATION OF THE OVEN
1. Open the bottom of the carton, remove oven,
all packing materials, Installation Instructions,
Wall Template, Top Template and Charcoal
Filter; however, DO NOT REMOVE THE
WAVEGUIDE COVER, which is located on the
ceiling in the oven cavity.
2. CHECK THE OVEN.
Check the oven for any damage, such as misaligned
or bent door, damaged door seals and sealing
surfaces, broken or loose door hinges and latches and dents inside the cavity or on the
door. If there is any damage, do not operate the oven and contact your dealer or SHARP
AUTHORIZED SERVICER.
3. Remove and save Screw (A) as shown in Figure 6.
4. Push down carefully on the tabs (B) and (C) at the ends of the Louver to disengage it.
Pull the Louver away from the unit and set aside.
5. Loosen the two Mounting Screws (D) which secure the Mounting Plate to the rear side
of the oven. Remove the Mounting Plate. See Figure 7
Figure 6 Figure 7