Specifications

Ver SG 9/200 40 Sharp Electronics Corporation
Testing method for the AH Sensor
To determine if the sensor is defective, the simplest method is to replace it with a new
sensor.
1. Disconnect the oven from the power line and remove the outer cabinet.
2. Discharge the high voltage capacitor.
3. Remove the AH sensor.
4. Install the new AH sensor.
5. Re-install the outer cabinet
a) Fill approx. 200 milliliters (7.2 oz) of tap water in a1000 milliliter measuring cup.
b) Place the container on the center of tray in the oven cavity.
c) Close the door.
d) Touch reheat pad once and touch the Start pad.
e) The control panel is in automatic Sensor operation.
f) The display will start to count down the remaining cooking time, and the oven will
turn off automatically after the water is boiling.
If new sensor does not operate properly, the problem is with the control unit.