Specifications

Ver SG 9/200 36 Sharp Electronics Corporation
On models which have the liquid crystal display, be sure to check the flex connector
between the display and control board. The conductor strip on the board as well as the
flex connector must be clean. Any substance, such as grease or dirt, would cause
resistance to current flow between these parts and impede the operation of the display.
Clean this area with a residue free cleaning agent such as ethyl alcohol. Also inspect the
control for a crack or break in the area where the mounting screws hold the assembly into
the frame. If the contact between the board and flex connector is not tight the display
will not function or will function erratically.
The function of audible signal elimination, will allow the consumer to turn off the buzzer.
The Demonstration mode, will allow the consumer to run through a cooking sequence at
ten times the normal speed without turning on the power circuits. The Child lock, will
allow the consumer to disable their control panel to prevent unwanted oven operation
Refer to the “owners guide”, not the service manual, for the specific model you are
working on to determine what features the unit has and the correct procedure used to
activate and deactivate the feature.
The Child Lock prevents unwanted oven operation such as by small children.
The oven can be set so that the control panel is deactivated or locked.
Should a pad be touched, Lock On will appear in the display.
Eliminates the audible signal when any of the pads are pressed.
The consumer can use the demonstration mode to demonstrate different features without
power being applied to the high voltage section.
NOTE: Refer to the owners manual for the model you are working on for the correct
procedure to activate and deactivate the above feature.
Child Lock
Audible Signal Elimination
Demonstration Mode