User guide

Installation

The mobile unit begins checking in and displays Searching for a DECT System.

This procedure should be completed very quickly. If the entries are not correct or

the radio connection is inadequate, a progress bar appears on the mobile unit. In

this case, cancel the procedure using the

Esc

softkey and repeat the subscription

with corrected entries.

Note:

When you prefix authentication code entry with the star key, the mobile unit will

be checked in as a GAP device.

Tip: The length and quality of the authentication code used

depends on your security requirements. Please keep in mind

that the memory required for the authentication code

increases 4 bits per additional digit.

After checking in successfully, you can enter name and number for the new sub-

scription entry. Confirm with the

softkey.

Note:

If you wish to subscribe the mobile unit to a GAP base station for instance, the

process is often started with a simplified procedure. In many cases, press a key on

the GAP base station to open a subscription time frame. During the time frame,

start the simplified subscription and confirm all requirements on the mobile unit

with the

softkey.

Z Enter Auth.Code: now enter the maximum 8-digit code that you

entered into the communications system Configurator.

Press softkey to confirm and continue.