Owner`s manual

Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
Only use the recommended mounting position,
otherwise the Intelligent Cruise Control (ICC)
sensor obstruction (if so equipped) may result.
● License plate bracket
● J-nut × 2
● Screw × 2
● Screw grommet × 2
SEDAN
1. Park the vehicle on flat, level ground.
2. Locate the center position
䊊
A
as illus-
trated. Position the license plate bracket
at a distance of approximately 0.35 in (9
mm)
䊊
B
from the bottom of the bumper.
Hold the license plate bracket in place.
3. Mark the center of the hole
䊊
C
with a
felt-tip pen.
4. Carefully drill two pilot holes using a 0.39
in (10 mm) drill bit at the marked loca-
tions. (Be sure that the drill only goes
through the bumper fascia.)
Sedan
STI0696
INSTALLING FRONT LICENSE PLATE
Technical and consumer information 9-15
췽 —
—
10/13/09—pattie
墍