Owner`s manual

1. To begin, push and hold the 2 outer
HomeLink姞 buttons (to clear the memory)
until the indicator light
䊊
A
blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held trans-
mitter 1-3 inches away from the
HomeLink姞 surface.
3. Using both hands, simultaneously push
and hold both the HomeLink姞 button you
want to program and the hand-held trans-
mitter button.
DO NOT release the buttons until step 4
has been completed.
4.
Hold down both buttons until the indicator
light on HomeLink姞 flashes, changing from
a “slow blink” to a “rapid blink”. This
could take up to 90 seconds. When the
indicator light blinks rapidly, both buttons
may be released. The rapidly flashing light
indicates successful programming. To ac-
tivate the garage door or other pro-
grammed device, push and hold the pro-
grammed HomeLink姞 button - releasing
when the device begins to activate.
5. If the indicator light on HomeLink姞 blinks
rapidly for two seconds and then turns
solid, HomeLink姞 has picked up a “rolling
code” garage door opener signal. You will
need to proceed with the next steps to
train HomeLink姞, completing the pro-
gramming may require a ladder and an-
other person for convenience.
6. Push and release the program button
located on the garage door opener’s mo-
tor to activate the “training mode”. This
button is usually located near the an-
tenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the
lens to access the training button.
NOTE:
Once you have pushed and released the
training button on the garage door open-
er’s motor and the “training light” is lit,
you have 30 seconds in which to perform
step 7. For convenience, use the help of a
second person to assist when performing
this step.
SIC3612 SIC3613
2-58 Instruments and controls
췽 —
—
10/12/09—tbrooks
墍