Specifications

<P=005>
RADIO OPERATION
■ Tuning
1 Set the function switch to TUNER.
2 Press the REPEAT/BAND ( ) button to select
the desired frequency band. (FM ST, FM or AM)
● To receive an FM stereo transmission, press the
REPEAT/BAND ( ) button so that the "ST" indi-
cator on the display lights up.
● The " " indicator lights up when an FM broad-
cast is in stereo.
3 Press the TUNING ( or ) button to tune into
the desired station.
FM STEREO
FM MONO
AM
ON/STAND-BY
(Function)
TUNER
MEMORY
PLAY / PAUSE
TUNING
STOP
TUNING
REPEAT
BAND
CUE
PRESET
REVIEW
PRESET
TUNING
/
PRESET
/
PRESET
TUNING
TUNER
MEMORY
CLEAR
BAND
Manual tuning:
Press the TUNING ( or ) button as many times
as required to adjust the frequency shown on the
display to the frequency of the desired station.
Auto tuning:
When the TUNING ( or ) button is pressed for
more than 0.5 seconds, scanning will start automat-
ically and the tuner will stop at the first receivable
broadcast station.
Notes:
● When radio interference occurs during auto scan
tuning, auto scan tuning may stop automatically
at that point.
● If a weak station signal is found during auto scan
tuning, the station will be skipped.
● To stop the auto tuning, press the TUNING (
or ) button again.
● If the FM reception is poor, press the RE-
PEAT/BAND ( ) button so that the "ST" indica-
tor goes out.
Although the reception changes to monaural, the
sound becomes clearer.
Aerial adjustment:
FM AM
After use:
Set the ON/STAND-BY switch to STAND-BY.
QT-CD250H(SUK) TINSE0043SJZZ
8
Downloaded from www.Manualslib.com manuals search engine
Downloaded From Disc-Player.com Sharp Manuals