User Manual

Recording to a Cassette Tape
Before recording:
● When recording important selections, make a preliminary test to en-
sure that the desired material is properly recorded.
● SHARP is not liable for damage or loss of your recording arising from
malfunction of this unit.
● The ALC (Automatic Record Level Control) circuit automatically con-
trols the level of the input signal used for recording.
● The VOLUME and X-BASS controls may be adjusted with no effect
on the recorded signal. (Variable Sound Monitor)
● Metal and CrO
2
tapes cannot be used for recording.
■ Recording from a CD
1 Set the FUNCTION switch to CD.
2 Load the disc to be recorded.
3 Load a blank cassette into the cassette compartment with the
side to be recorded on facing toward you.
4 Press the RECORD ● button.
5 Press the PLAY/PAUSE
0 60 6
0 60 6
0 6 button on the CD.
To stop recording:
Press the STOP/EJECT
■
7 button.
If the STOP ■ or PLAY/PAUSE 0 6 button is pressed whilst recording, or if
the CD comes to its end, the tape deck will not stop.
To record a specific track:
Press the REVIEW/DOWN 5 or CUE/UP 4 button until the desired track
number is displayed, then start recording.
■ Recording from the radio
1 Set the FUNCTION switch to FM or AM.
2 Tune in to the station to be recorded.
3 Load a blank cassette into the cassette compartment with the
side to be recorded on facing toward you.
4 Press the PAUSE
66
66
6 button.
5 Press the RECORD ● button.
● If a whistling noise occurs when recording from an AM station, set the
BEAT CANCEL switch (on the bottom of the unit) to A or B, whichever
gives the best reception.
6 Press the PAUSE
66
66
6 button again.
To stop recording:
Press the STOP/EJECT
■
7 button.
■ Erasing a recorded tape
1 Set the FUNCTION switch to TAPE.
2 Load a tape into the cassette compartment with the side to be
erased facing toward you.
3 Press the RECORD ● button.
E-7