Operating instructions

<P=002>
RECORDING
● When recording important selections, be sure to
make a preliminary test to ensure that the desired
material is being properly recorded.
● The ALC (Automatic Record Level Control) cir-
cuit automatically controls the level of the input
signal used for recording.
● The VOLUME control may be adjusted with no
effect on the recorded signal. (Variable Sound
Monitor)
● Metal and CrO2 tapes cannot be used for record-
ing.
■ Recording from the built-in CD player
1 Set the function switch to CD.
● Load the disc to be recorded.
2 Load a blank cassette into the cassette compart-
ment with the side to be recorded facing up.
3 Press the RECORD button.
4 Press the PLAY/PAUSE ( ) button on the CD.
To stop recording:
POWER
(Function)
STOP
TUNING
PLAY / PAUSE
TUNING
REPEAT
BAND
Press the STOP/EJECT button.
The tape will stop.
Note:
● If the STOP(■) or PLAY/PAUSE ( ) button
on the CD player is pressed while recording, or
if the CD comes to its end, the tape deck will not
stop.
To record a specific track:
Press the UP ( ) or DOWN ( ) button
on the CD player until the desired track number is
displayed, then start recording.
■ Recording from the built-in radio
1 Set the function switch to TUNER.
● Tune in to the station to be recorded.
2 Load a blank cassette into the cassette compart-
ment with the side to be recorded facing up.
3 Press the PAUSE button.
4 Press the RECORD button.
5 Press the PAUSE button again.
To stop recording:
Press the STOP/EJECT button.
■ Erasing a recorded tape
1 Set the function switch to TAPE.
2 Load a tape into the cassette compartment with
the side to be erased facing up.
3 Press the RECORD button.
HEADPHONES
● Before plugging in or unplugging the head-
phones, make sure the volume level is reduced.
● Be sure your headphones have a 1/8" (3.5 mm)
diameter plug and are between 16 ohms and 50
ohms impedance. The recommended im-
pedance is 32 ohms.
● Connect the headphones plug to the PHONES
jack located on the rear of the unit. The speakers
will be automatically disconnected. Adjust the
volume by using the VOLUME control.
QT-CD250(SEC) TINSE0040SJZZ
11