User Manual

E-5
Recording on a Cassette Tape
Before recording:
● When recording important selections, make
a preliminary test to ensure that the desired
material is properly recorded.
● SHARP is not liable for damage or loss of
your recording arising from malfunction of
this unit.
■ Recording from the radio
1 Set the FUNCTION switch to RADIO.
2 Set the BAND SELECTOR switch to FM,
MW, SW1 or SW2.
3 Tune in to the station to be recorded.
4 Load a blank cassette into the cassette
compartment with the side to be record-
ed on facing you.
5 Press the PAUSE
66
66
6 button.
6 Press the RECORD ● button.
7 Press the PAUSE
66
66
6 button again to be-
gin recording.
To stop recording:
Press the STOP/EJECT
■
7 button.
● The ALC (Automatic Record Level Control)
circuit automatically controls the level of the
input signal used for recording.
● The VOLUME control may be adjusted with
no effect on the recorded signal. (Variable
Sound Monitor)
● Metal and CrO
2
tapes cannot be used for
recording.
■ Recording from the built-in
microphone
1 Set the FUNCTION switch to TAPE.
2 Load a cassette into the cassette com-
partment.
3 Press the PAUSE
66
66
6 button.
4 Press the RECORD ● button.
5 Press the PAUSE
66
66
6 button again to be-
gin recording.
Note:
● Monitoring of the recording is not possible.
STAND-BY
QT-222W(B) 92L20101550040
QT-222W(B)_E.pm 03.10.24, 11:55 AM12