User Manual

44
Using external equipment
Option
MENU
Input Select
Input 1 [AV]
RGB
AV
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
P B (C B )
COMPONENT
P R (C R )Y
R - AUDIO - L
INPUT 3
INPUT 2 INPUT 1
RS-232C DISPLAY OUTPUT-1
DISPLAY OUTPUT-2
AC INPUT
220–240V
AV OUTPUT
S-VIDEO VIDEO
AVC System (rear view)
Decoder
SCART cable
(commercially available)
Watching a decoder image
Connecting a decoder
You can use the INPUT 1 terminal when connecting a decoder and other audiovisual equipment.
Displaying a programme
When connecting to the INPUT 1 terminal, select “Input
1” on “Input Select” in the menu to set the correct input
signal type. (See page 52.)
The setting is stored and can be selected on the
“INPUT SOURCE” menu.
To watch a decoder image, select “INPUT1” from the
“INPUT SOURCE” menu using b on the remote
control unit or INPUT on the Plasma Display TV (Panel
Unit). (See page 52.)
A
• Each time b is pressed, the input source toggles.
• If the decoder image does not come in clearly, you may
need to change the input signal type setting on the “Input
Select” menu.
• It is recommended to connect to the INPUT 1 terminal
when using a decoder for ground wave signal input. If
INPUT 1 signals preset in auto installation or programme
setup, make sure to set “Decoder” to “INPUT1” in the
Programme Setup “Manual” menu. (See page 34.)
• Refer to your decoder operation manual for the signal type.