User Manual

11
PB(CB)
COMPONENT
PR(CR)Y
R - AUDIO - L
INPUT 3
INPUT 2 INPUT 1
RS-232C DISPLAY OUTPUT-1
DISPLAY OUTPUT-2
AC INPUT
220–240V
AV OUTPUT
S-VIDEO VIDEO
System cable
AVC System (rear view)
Power cord
Plasma Display TV (Panel Unit) (rear view)
Power cord
System cable
(bottom view)
(GRAY)
(WHITE)
(GRAY)
(WHITE)
Setting the system
1. Connecting the system cable, the power cord and the speaker cables to the Plasma Display TV (Panel
Unit)
2. Connecting the system cable and the power cord to the AVC System
L
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
POWER CORD CONNECTED.
Preparation
Speaker cables
(GRAYeGRAY with white stripe)
Speaker cable
Speaker cable
As you apply pressure to this part,
insert the speaker cable. It is
important to match polarity when
connecting the speaker cables to the
terminals.
Insert the speaker cable
Lift up the snap clip.
Insert the wire into
the hole of the
connector.
Lower the snap clip
to grip the wire in
place.
Black
Red
Black
Red
A
• Two speaker cables of different lengths are supplied. As
shown in the diagram, connect the longer speaker cable
to the left speaker and the shorter to the right.