User's Manual

6
You can control tracks being played back and the volume of the party
speaker on your external device. The functions available when using an
audio playback device on the party speaker will depend on your external
device and the software used.
Press and hold
button (for 3sec.) to disconnect the current Bluetooth
connection. The PS-929 will prompt “disconnected”.
nd and pair with the "SHARP PS-929".
AUX-IN OPERATION
You can use the AUX IN connection to connect an external playback device
(for example a CD player or MP3 player).
unit with an AUX IN cable. (not supplied with the device)
/MODE button several times until you see AUX in the
display.
The audio signal from your external device will now be played back.
The track being played back is controlled via the external device. The
volume can be controlled both on your external device and the party
speaker.
USB OPERATION
This unit provides two USB ports, one for playback, and another for
charging.
USB slot 1 on the rear panel of the party
speaker.
will play the songs from the USB immediately.
or button to select the previous or next track
le formats, compatibi-
lity with the connected memory media cannot be guaranteed.
the system to be detected.
le format is MP3/WAV/FLAC.
USB Charge
The unit has a bulit-in 5V 1A charger, to charge an external USB Device:
1. Connect the USB plug from the external USB Device to 5V 1A port on
the top of unit.
2. Power on the main unit, then the charging will automatically start.
Connect guitar
The guitar can be used in any operating mode. To connect the guitar,
proceed as follows:
plug GT.IN.
MIC/GUITAR
VOL knob to select the desired guitar volume
Connecting a microphone
MIC.IN plug on
the rear of the speaker.
MIC/GUITAR VOL knob to select the desired microphone
volume.
EQ/ECHO ect.
TWS/ True wireless Stereo - Duo Mode
• This allows for two PS-929 party speakers to be connected together
rst
connected speaker is the master one and the second the slave.
•
rst speaker until the
speaker says “Duo Mode pairing” then release the buttons.
• Ensure the second speaker is in Blueetooth mode, did not connected to
any devices and ready for pairing.
• Please wait until both speaker says “Duo Mode connected”. The speakers
are now connected to each other.
• The speaker that display "BT-L" is the master speaker and this is the
speaker that you should pair with your phone.
• For Bluetooth pairing to a Bluetooth-out enabled smart device search for
"SHARP PS-929" on your device and pair.
•
• When you Power on the speakers, they need to be turned on
individually.
• When both speakers are powered on Duo Mode will automatically
reconnect and you will hear “Duo Mode connected”.
• To disconnect Duo Mode press and hold SUPER BASS button until you
hear “Duo Mode disconnected”
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
The term “IC: “ before the certification/registration number only signifies
that the Industry Canada technical specifications were met. This product
meets the applicable Industry Canada technical specifications.
Cet appareil contient des émetteurs / récepteurs exemptés de licence
conformes aux RSS (RSS) d'Innovation, Sciences et Développement
économique Canada. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptibled & apos; en
compromettre le fonctionnement.