User manual
Table Of Contents
- Connecting Pin Assignments
- RS-232C Specifications and Commands
- Operating the Projector Using the PJLinkTM Protocol
- Setting up the Projector Network Environment
- Controlling the Projector via LAN
- Controlling the Projector Using Internet Explorer
- Confirming the Projector Status (Status)
- Controlling the Projector (Control)
- Setting and Adjusting the Projector (Settings & Adjustments)
- Setting the Security (Network ‐ Security)
- Making General Settings for the Network (Network - General)
- Setting for Sending E-mail when an Error Occurs (Mail ‐ Originator Settings)
- Setting Error Items and Destination Addresses to which E-mail is to be Sent when an Error Occurs (Mail ‐ Recipient Settings)
- Setting Error Items and the URL that are to be Displayed when an Error Occurs (Service & Support ‐ Access URL)
- Resetting the Lamp Timer of the Projector via LAN
- Troubleshooting
-23
5
Click “Properties” on the “File”
menu.
6
Click the “Settings” tab, and then
click “ASCII Setup”.
7
Select the check boxes next to
“Send line ends with line feeds”,
“Echo typed characters locally”,
and “Append line feeds to
incoming line ends”, and click
“OK”.
The LAMPRESET Properties window
appears, click “OK”.
8
If a user name and/or password is
set for the projector, enter the
user name and password.
9
Send the lamp reset command
“LPRE0001”.
This command can only be sent when the
projector is in standby mode.
When “OK” is received, this indicates that the
lamp was successfully reset.
10
Close HyperTerminal.
•
•
•
5
6
7
8
9
1
0
Resetting the Lamp Timer of the Projector via LAN