Operation Manual
Table Of Contents
- Introduction
- Preparations
- Wireless mode screen
- Displaying the computer screen
- Actions when a screen is displayed (touch-applicable models only)
- Exiting
- Settings
- Starting from a commercially available USB flash drive
- Uninstalling the connection software
- Using as a whiteboard (Direct Drawing) (touch-applicable models only)
- Intellectual Property Rights and Other Matters
7
E
n
Connecting the wireless board to an existing network by wireless LAN
Connect the wireless board and computer to an access point of the existing network by wireless LAN.
Connect to the wireless LAN access point
Wireless
LAN
access
point
Network
Computer
• Set the wireless board appropriately for the existing network access point.
• Set the wireless board to client mode. (See page 30.)
n
Using an existing network access point to display the screen of 1 computer on multiple
monitors
You can display a screen on up to 4 monitors.
Connect the wireless board to the existing network by wired LAN.
Connect the computer to the wireless board from an existing access point.
Network
Computer
Wireless
LAN
access
point
Connect by wired LAN
(maximum of 4)
• Set the wireless board appropriately for the existing network.