Operation Manual
Table Of Contents
- Introduction
- Preparations
- Wireless mode screen
- Displaying the computer screen
- Actions when a screen is displayed (touch-applicable models only)
- Exiting
- Settings
- Starting from a commercially available USB flash drive
- Uninstalling the connection software
- Using as a whiteboard (Direct Drawing) (touch-applicable models only)
- Intellectual Property Rights and Other Matters
32
E
You can enable starting of the connection software from a commercially available USB ash drive.
USB ash drives that can be used:
• USB ash drives indicated operation manual with a capacity of 128 MB or more.
• Use a USB ash drive in which nothing is saved.
1. Insert the USB ash drive into the USB port of the wireless board.
Touch-applicable models:
2. Touch “Setup” (
) in the home screen of Wireless mode.
3. Touch “Create Token”.
Creating starts.
4. When the making completed message appears, remove the USB ash drive.
Other than touch-applicable models:
2. Press INFORMATION button three times on the remote control unit in OPTION input mode to display the
INFORMATION3 screen.
3. Press ENTER button to display CREATE TOKEN screen.
4. Press
or to select the OK, and press ENTER button.
Creating starts.
5. When the creating completed message appears, remove the USB ash drive.
Caution
• Do not remove the USB ash drive while making is in progress.
And do not turn off the power of the monitor.
• Always create this on the wireless board.
Incorrect operation will result if you copy the le from the wireless token to the USB ash drive using your computer.
TIPS
• When the USB ash drive connection software is started, the software will automatically connect to the wireless board on
which the wireless token was created. (The software will also connect automatically over wireless LAN.)
Starting from a commercially available
USB ash drive