Operation Manual
Table Of Contents
- IMPORTANT INFORMATION
- DEAR SHARP CUSTOMER
- SAFETY PRECAUTIONS
- TIPS AND SAFETY INSTRUCTIONS
- MOUNTING PRECAUTIONS
- Supplied Components
- Part Names
- Connecting Peripheral Equipment
- Connecting the Power Cord
- Binding Cables
- Preparing the Remote Control Unit
- Turning Power On/Off
- Basic Operation
- Remote Control Mode
- Menu Items
- Initialization (Reset)/Functional Restriction Setting (FUNCTION)
- Controlling the Monitor with a computer (RS-232C)
- Controlling the Monitor with a computer (LAN)
- Troubleshooting
- Specifications
- Mounting Precautions (For SHARP dealers and service engineers)
20
E
Basic Operation
When performing operation of multiple monitors with the
remote control unit, rst set the remote control unit to the
appropriate remote control mode (see page 23).
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
TIPS
• You can perform operation of the monitor with the rear
buttons. Utilize the buttons belonging to the monitor that
you would like to operate.
• Operation by using the buttons on the rear side of the
product will perform the same functions.
Rear side buttons
Remote control
unit buttons
This manual assumes that this product will be used with the
remote control unit buttons, except where specically noted.
1. HDMI
Switch the input mode to HDMI1 or HDMI2.
2. Numeric input buttons
When HDMI CEC LINK is set to AUTO, use these buttons to
operate the device connected through the HDMI interface.
0 to 9 are also used in conjunction with the ID SET button.
3. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
If using the monitor buttons, either hold both the MENU button
and
button at the same time or select MUTE AUDIO from
the OTHERS menu.
4. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB →
HIGH ILLUMINANCE → STD...
• HIGH ILLUMINANCE is a display with colors suited to
bright locations.
•
sRGB cannot be used when input mode is D-SUB[COMPONENT].
sRGB is international standard of color representation
specied by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crystal’s characteristics and represents color tone
close to its original image.
• If using the monitor buttons, select COLOR MODE from the
COLOR ADJUSTMENT of the PICTURE menu.
• You can press for about 5 seconds to change the remote
control mode. (See page 23.)
5. VOLUME +/- (Volume adjustment)
Pressing + or - displays the VOLUME menu.
V OLUME 15
Press + or - to adjust the volume.
If using the monitor buttons, select VOLUME of the OTHERS
menu.
* If you do not press any buttons for about 4 seconds, the
VOLUME menu automatically disappears.