Operation Manual

E
19
5. BRIGHT +/- (Backlight adjustment)
Pressing
or displaystheBRIGHTmenuwhenthe
menu screen is not displayed.
BRIGHT 15
Press or toadjustthebrightness.
* If you do not press any buttons for about 4 seconds, the
BRIGHTmenuautomaticallydisappears.
* WhenBRIGHTNESSSENSORisONorON:DISPLAY,
whenthebrightnessisadjustedBRIGHTNESSSENSOR
willbecomeOFF.
6. SIZE (Screen size selection)
The menu is displayed.
Press
or toselectthescreensize.(Seepage20.)
Ifusingthemonitorbuttons,selectSIZEfromtheOPTION
menu.
7. DISPLAY
Displaysmonitorinformation.Whenyoupressthisbutton
again, the display disappears.
INPUT MODE
SIZE
COLOR MODE
BRIGHT
VOLUME
ID No.
MODEL
S/N
STATUS
REMOTE CONTROL SENSOR BOX
:
:
:
:
:
:
:
:
:
:
INFORMATION
1920x1080
V: 60 Hz H: 67.5 kHz
PC D-SUB
WIDE
STD
31
15
0
PN-V602A
XXXXXXXX
0000-0000-0000-0000
NOT CONNECTED
01/01/2016 FRI 00:00:00
WhenthePN-ZB02(optional)isattached,thedisplaychanges
fromINFORMATION1→INFORMATION2→cleardisplay,
and so on every time you press this button.
• Thedisplaydisappearsautomaticallyafterabout15
seconds.
•
LAN
is displayed during LAN communication.
• If
LAN
is displayed in red, there is a duplicate IP address.
If using the monitor buttons, press
underINFORMATIONin
the OPTION menu.
8. MODE (Color mode selection)
Eachtimeyoupressthisbutton,thecolormodechangesin
the following order:
STD(Standard)→VIVID→sRGB→
HIGHILLUMINANCE→STD...
• HIGHILLUMINANCEisadisplaywithcolorssuitedto
bright locations.
• sRGBappliestoPCinputonly.
 sRGBisinternationalstandardofcolorrepresentation
speciedbyIEC(InternationalElectrotechnical
Commission).Colorconversionismadeintakingaccount
ofliquidcrystal’scharacteristicsandrepresentscolortone
close to its original image.
Ifusingthemonitorbuttons,selectCOLORMODEfromthe
PICTUREmenu.
Basic Operation