Operation Manual

67
E
Specications
n
Dimensional Drawings
Note that the values shown are approximate values.
3-9/16
[91]
7-7/8
[200]
11-13/16
[300]
11-13/16
[300]
VESA holes
Opening width (70-5/16 [1786.4])
33-1/4 [844]
73-3/8 [1863]
Opening height
(
39-11/16 [1008.2]
)
44-3/16 [1123]
2-7/16
[62]
1-13/16
[46]
46-1/8 [1172]
3-7/8
[98]
42-15/16 [1090]
Unit: inch [mm]
7-7/8
[200]
When mounting the monitor, be sure to use a wall-mount bracket that complies with the VESA-compatible mounting method.
SHARP recommends using M6 screws and tighten the screws.
Note that screw hole depth of the monitor is 3/8 inch (10 mm). Loose mounting may cause the product to fall, resulting in serious
personal injuries as well as damage to the product. The screw and hole should come together with over 5/16 inch
(8 mm) length of thread. Use a bracket which has been approved for UL1678 standard, and which can endure at least 4 times or
more the weight of the monitor.
n
Power management
This monitor conforms to VESA DPMS. Both your video card and computer must support the same standard in order for the
monitor’s power management function to work.
DPMS: Display Power Management Signaling
DPMS Screen
Power
consumption
Hsync Vsync
ON STATE Display 325 W Yes Yes
STANDBY
No
display
7.0 W*
No Yes
SUSPEND Yes No
OFF STATE No No
* When CONNECT AUTO INPUT SELECT and NO SIGNAL AUTO INPUT SEL. are set to OFF.