Operation Manual

36
E
Specications
n
Product Specications
Model
PN-65SC1
LCD component
65" Class [64-1/2 inch (163.9cm) diagonal] TFT LCD
Max. resolution (pixels)
1920 x 1080
Max. colors
Approx. 16.77 million colors
Pixel pitch
0.744 mm (H) × 0.744 mm (V)
Max. brightness (typical)
*
1
350 cd/m
2
Contrast ratio (typical) 5000 : 1
Viewing angle
178° right/left/up/down (contrast ratio ≥ 10)
Screen active area inch (mm)
56-1/4 (W) x 31-5/8 (H) (1428.5 x 803.5)
Computer input signal
Analog RGB (0.7 Vp-p) [75
Ω
],
HDMI
, DisplayPort
Sync signal
Horizontal/vertical separate (TTL: positive/negative)
Plug and play
VESA DDC2B
Power management
VESA DPMS
Input terminals
Video HDMI x 4
DisplayPort x 1
Mini D-sub 15 pin, 3 rows x 1
Audio
3.5 mm mini stereo jack x 1
Serial (RS-232C) D-sub 9 pin x 1
Output terminals Audio
3.5 mm mini stereo jack x 1
USB port Type A (USB 2.0 compliant) x 2
Speaker output 10 W + 10 W
Touch Panel
Detection method Infrared blocking detection method
Computer connector USB (2.0 compliant) (type B) x 1
Expansion slot
12 V, 2.5 A
(power supplied when expanding the functions with an optional part)
Power requirement AC 100 V - 240 V, 2.4 A, 50/60 Hz
Operating temperature
*
2
*
3
41°F to 95°F (5°C to 35°C)
Operating humidity
*
3
20% to 80% (no condensation)
Power consumption
(maximum / input signal waiting mode
*
4
*
5
/ standby mode
*
6
)
205 W/2.0 W/0.5 W
Dimensions (excluding protrusions) inch (mm)
Approx. 59-7/8 (W) x 3-7/8 (D) x 37-1/2 (H) (1521 x 99 x 952)
Weight lbs. (kg)
Approx. 126.8 (57.5)
*1 Brightness will depend on input mode and other picture settings. Brightness level will decrease over time. Due to the nature of the
equipment, it is not possible to precisely maintain a constant level of brightness.
*2 Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such
cases, please check the temperature condition specied by the optional equipments.
*3 In addition, check the requirements of the computer and other devices to be connected, and make sure that all requirements are satised.
*4 When the optional part is not installed.
*5 When RESUME BY TOUCH is set to OFF.
*6 When POWER SAVE MODE is set to ON.
When POWER SAVE MODE is set to OFF: 2.0 W
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specication changes for product improvement
without prior notice. The performance specication gures indicated are nominal values of production units. There may be some deviations from
these values in individual units.