Operation Manual

27
E
Menu Items
n
MONITOR (
)
OSD H-POSITION
Adjusts the horizontal display position of menu screen.
OSD V-POSITION
Adjusts the vertical display position of menu screen.
OPERATION MODE
MODE1 ...... OFFIFNOOPERATIONissettoON,andPOWERSAVEMODEissettoON.
(These settings cannot be changed.)
MODE2 ...... Willperformstandardoperation.OFFIFNOOPERATIONissettoOFF,andPOWERSAVEMODEissettoOFF.
These settings can be changed.
POWER SAVE MODE
WhenOFFisselected,startuptimefromstandbymodeisreduced.Note,howeverthat,morepowerwillbeconsumedin
standby mode.
WhenONisselected,currentconsumptionisreducedwhilethemonitorisinstandbymode.Note,however,thatthestartup
time from standby mode becomes longer.
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit
or RS-232C commands for over 4 hours.
n
PIP (
)
PIP MODES
Sets the display method.
OFF ....................Displays one screen.
PIP ......................Displays a sub screen inside a main screen.
PbyP ...................Displays a main screen and a sub screen in a line.
PIP SIZE
Sets the size of the sub screen in PIP mode.
PIP POS
Adjusts the position of the sub screen in PIP mode.
PIP SOURCE
Selects the input signal of the sub screen in PIP or PbyP mode.
SOUND CHANGE
Sets the sound which is output in PIP or PbyP mode.
RESET
Resets the values of the PIP menu items to the factory preset values.
Select ON and then press the ENTER button.